User`s manual

19
Make the settings for the cutting
conditions. Clicking [NEXT]
advances the setting screens in
sequence from A to D. Make the
settings in order from A to D.
(Clicking A, B, C, or D in the
figure displays the corresponding
setting screen, this should not be
used except when it's necessary
to make settings independently.)
4
A
B
C
D
This displays the path of
the tool during cutting.
Click here to advance to
the next settings.
A Select the direc-
tion of the object
Select the direction to be used
for cutting the object.
In the figure at right, cutting
from above is selected.
B Set the dimension
Make the setting for object's
size.
Drag the spin dial up or down,
or click on a number and enter a
value from the keyboard.
Clicking [Resize] makes it
possible to specify a ratio for the
dimensions.
C Set the maximum
cutting depth
Make the setting for the
maximum cutting depth.
Drag the spin dial up or down,
or click on a number and enter a
value from the keyboard.
Clicking [Center] sets the depth
at a location proportional to the
height.
D
Tool diameter
Set the type and diameter of the
tool that is installed.
Material
Choose the composition of the
loaded material.
Finish
When cutting a solid object on a
modeling machine, an attractive
finish can be obtained by first
performing rough (draft) cutting,
then performing fine cutting. Set
to [Draft] for the first pass, and
to [Fine] for the second pass.