User`s manual

17
Cancels scanning
Cancels scanning.
Any data scanned
before being canceled
remains in memory.
Pauses scanning and
moves the sensor to
the VIEW position.
Click [VIEW] again to
resume scanning.
Pauses scanning
6
Setting the scanning area
If you wish to limit the scanning area, such as in cases where you wish to scan only a portion of an object, make the settings as described
below.
Click in the Remote Controller window. The [Scanning Area] dialog box appears.
1
Make the settings for the scanning area.
Make the settings to match the location where the scan object is secured in place.
Either of the following two methods can be used to make the settings.
- Use the mouse to move the blue frame on screen.
- Enter the numerical values for the upper-right and lower-left points.
In this case, enter the following information.
UR: X 107.5 (4.232") Y 62.50 (2.461")
LL: X 27.50 (1.083") Y 27.50 (1.083")
The size of the on-screen scanning area (shown in blue) changes to match the values that are entered.
2
Click [Begin Area Test].
The sensor moves to a position above an outer point on the scanning area that has been set.
Make sure the scan object that has been secured in place lies within the area.
3
Click [Z Upper Limit].
The cursor
is displayed on the Z upper-limit setting on screen.
Specify the highest position of the scan object and click [Apply].
If the target is displaced, redo the settings.
4
After determining the scanning area, click [OK].
5
5
4
4
• For the scanning area and Z upper limit,
please refer to "About scanning condi-
tions and the scanning area".
• For details about the buttons on the
scanning-region setting screen, please
refer to the help screens for Dr. PICZA.
4
3
2
Check the scanning conditions in the Remote Controller window one more time, then click .
Scanning starts. (During scanning, the sensor may emit a transmission sound, but this is normal.)