User`s manual

14
In this section, we'll prepare a
three-dimensional object made out
of clay, then carry out the steps
from securing the object to the
workpiece plate to saving the data.
The explanation in this section is
for a fish made with the clay that is
included.
Z: 5 mm (0.2")
Y: 30 mm (1-3/16")
X: 75 mm (2-15/16")
Workpiece plate
Maximum
scanning area
Maximum scanning area
of the PIX-3
The maximum scanning area is shown in the figure.
8 Load the object to be scanned on the PIX-3
The sensors for the PIX-3 are highly sensitive, and can even scan three-dimensional objects made out of clay.
Any solid object made of material that can hold its shape can be scanned.
Loosen the plate mounting screws.1 Slide the workpiece plate toward the rear.2
Mounting screw
Hole in the
workpiece plate
Securing in place with clay
Remove the workpiece plate.
3
Use clay to fashion a base on the workpiece plate.
4
10 mm (0.39")
ClayWorkpiece plate