Specifications

65
Part 5 Many Kinds of Printing and Settings
[Copies]
This specifies the number of copies to print. You can specify a number within the range of 1 to 99.
[Media Handling]
This makes settings related to media feed.
[Form Feed] When the check box is selected, then when printing finishes, the media is fed out to the end of the
media size, then further fed out by the length specified for [Page Spacing], and then printing ends.
When the check box is not selected, then when printing of the first page finishes, the media is
returned to the start of the media size and printing ends.
Note that the check box is selected automatically when you print the next page.
[
Cut Media After Printing ] When the check box is selected, the media is cut off at each page at the ending position for [Form
Feed].
When the check box is not selected, the media is not cut off.
Also, when [Form Feed] is not selected, you can not choose [Cut Media After Printing].
[Pre-Feed] When the check box is selected, then before printing starts the require length of media is fed out to
ensure that enough media remains to allow printing. Normally you perform output with this check
box left selected. In "4.2 Output from a Compatible Program," go to "Executing Printing and
Cutting" and refer to "About Prefeed."
[Page Spacing] This specifies the additional length of media to feed out after printing corresponding to the media
size finishes.
This setting does not change even if the settings for [Media Type] or [Media Size] are changed.
When the [Crop Marks] check box is selected, the minimum value is 3 cm.
[What to Cut]
This specifies what lines in the output data are recognized as cutting line.
Depending on the program used to create the output data, cutting may not take place using the method you specify.
If this happens, then select [by Color] and use the program used to create the data to set the line width of the lines you want to
make cutting to the minimum value.
For more information, go to "4.2 Output from a Compatible Program" and refer to "Specifying the Cutting Line."
[by Color] Specify the RGB value for the color of the line that is to be the cutting line.
Select the option, then click the color chip to the right of the option.
When the [Color Setting] dialog box appears, specify the
numerical RGB value for the color of the cutting line.
After you have made the setting, click [OK].
[by Line Type] Specify the width of the line that is to be the cutting line.
Select the option to display a dialog box for choosing the line type, then click to select. When the
menu appears, select the line type.
[All] This cuts all vector data contained in the output data.
[None] This makes all data printing data, so no cutting is performed.
[Cutting Polygons] Normally you perform output with this check box left selected.
If smooth cutting cannot be performed, then clear the selection. Cutting may be performed normally.
A polygon here refers to a drawing command used when the program processes shapes, and does not
refer to a drawn multi-sided shape.