Specifications

32
Part 3 Getting Ready
3
The tool carriage is located to the right of the ink-ribbon
cartridge carriage.
Turn the tool-carriage screw counterclockwise to loosen it.
4
Insert the blade holder into the hole in the carriage.
2
Press the front-cover eject button, and after the inside lock
has been released, catch the front cover with your hand and
open it gently.
Tool carriage
Blade holder
Front-cover eject
button
Installing the Blade Holder
Install a blade holder with blade installed into the tool carriage of the PC-12.
1
Switch off the power to the PC-12.
Before you first turn on the power after purchasing the PC-12, the place where you install the blade holder may not
be visible. Be sure to switch the power on once, then off again.
Tighten the screw on the tool carriage just enough so that there is no play in the blade holder. Overtightening may
cause damage.
NOTICE