Specifications

Quickstart to Roland MDX-40 and Modela Player 4

Appendix

Cutting Area - This sets the cutting area in the X and Y

directions.

When All is selected, the tool passes along the inner sides of the

contour radii in the area.

When Partial is selected, the tool passes along the contours in

the area. Note that the tool is restricted from passing beyond

the margins.

New Process Creation - Cutting Area

Depth

This sets the upper and lower edges (the ceiling and

oor) of the cutting depth.

For Start Height, enter the cutting-start height. For End

Height, enter the cutting-end height.

Enter heights from Z

0. If the depth position is lower

than Z

0, put a minus sign (“-”) in front of the value.

Rotate

tool

Move

tool

Zoom

tool

Fit to

window

tool

Selection

tool

Drag red

pointer

tool

Change

depth tool

Clicking Partial to select it allows you to change the area and depths in the preview.

To change the cutting area, follow the steps below.

Click

Drag the red pointer ( )

To change only positions without changing the width of the area, drag the inner sides of the red

rectangles. To change the depth, follow the steps below.

Click

To change the cutting-start height, drag the blue line ( )

To change the cutting-end height (the bottom), drag the red line ( )

To cut deeper than the bottom of the modeling form, select Extend Depth Limit. You use this

when you want to eliminate all uncut areas at the bottom of the model and create contours.