Specifications

Quickstart to Roland MDX-40 and Modela Player 4

Appendix

Overlap - shows the range in which cutting overlaps

an opposing surface.

The overlapping range is cut from both surfaces.

This is calculated from the cutting depths of the top

and bottom (or front and back) surfaces.

When the amount of overlap is zero, uncut areas

may remain.

Bottom (Back) depth - the cutting depth for the

bottom (back) surface.

This determines the maximum cutting depth for the

corresponding surface.

When you’re performing multiple-surface cutting,

you cannot enter a value that makes the amount of

overlap less than zero.

Center

This sets the depth of the top and bottom surface

(or the front and back) at the center of the model.

Depth tab

Tool page

Rotate

tool

Move

tool

Zoom

tool

Fit to

window

tool

Preview

window

Selection

tool

Tool - Choose the tool to use in this process.

You cannot choose a tool for which no cutting parameters have

for the material have been registered.

To register cutting parameters, quit this wizard temporarily, then

go to Options > Register Cutting Parameters.