Specifications

Quickstart to Roland MDX-40 and Modela Player 4

Example 4

Step 22

Step 21

Cutting Position

A dialog box will keep track of the progress of

cutting starting with Roughing1 and Finishing1,

through a progress bar.

Click Continue to proceed with cutting.

Click on the Cut tool at the bottom of the interface. This will be the nal command to issue, where the data from the 3D

model is sent to the MDX40 machine for cutting. Click OK to cut.

On selecting the Cutting Position icon, the

Tool-up Height dialog box appears. A safe

height value will be displayed here. You can

either enter a value higher than the value

given here and accept the defaults. If you

try entering a lower value than that, it will

prompt you an error message. You shall be

required to re-enter a correct value again.*

Click OK to close.

Output cutting to MDX-40

Set Tool-up height

*see Appendix B for more explanations

Cut