Specifications

Quickstart to Roland MDX-40 and Modela Player 4
10
Copyright © Freeform Digital
Example 1
Next, check on the Set the Z-axis origin
using the sensor at the Reference-Point
Settings section.
Click on the Start Detection button.
Step 6
A Setup dialog box appears, instructing
you to place your cutting tool just
above the sensor.
Click the Continue button.
Step 7
The software will now start to set the
Z-axis origin for you. The tool will move
down and detects the sensor a few times.
Once detected, it will return back to the
previous position. The dialog box will close
automatically. After this, remember to remove
the sensor from the work piece as we DO
NOT need it anymore.
However, if the tool cannot correctly detects
the sensor properly after a few times, simply
click the Quit button to exit and try again.
sensor
Detect Z-axis
Set Z origin