User Manual

88
8. NC Code Specications
NC Code Specications
List of Settings Related to NC Codes
This section lists the settings that can be performed from this machine among the settings related to NC code interpretation
and execution. Perform all other settings from the NC program.
" "NC Code Reference Manual" (electronic-format manual)
* To congure settings related to NC codes, set the command set to "NC code" or "Automatic switching between RML-1
and NC code."
" P. 51 ""Machine" Tab"
Setting Setting method Remarks
Numeric value inter-
pretation method
In VPanel, open the "Settings" dialog box, the "NC
code setting" dialog box, and then use the [NC code]
tab to congure the settings.
Select how to interpret numer-
ic values that have a decimal
point and the range of calcu-
lator interpretation.
Workpiece origin
offset
(G54 to G59)
Use the VPanel [Setting Reference Point] to select the
target coordinate system, and then set the reference
point. However, you can also use G10 and G92 to
congure the setting in an NC program.
This setting is related to the
workpiece coordinate system
origin positions.
EXOFS 1. Set the display of the coordinate system in VPanel
to [Machine coordinate system].
2. Specify the X, Y, and Z coordinate values in the
"Moving to an Arbitrary Location" dialog box.
3. Select [EXOFS] for the [Setting Reference Point].
4. Select [Set X-, Y-, and Z-origins here], and then
click [Set].
However, you can also use G10 to configure the
setting in an NC program.
Tool diameter cor-
rection values
In VPanel, open the "Settings" dialog box, the "NC
code setting" dialog box, and then use the [Tool-di-
ameter oset] tab to congure the settings. However,
you can also use G10 to congure the setting in an
NC program.
Tool-diameter offset
type
(G41 and G42)
In VPanel, open the "Settings" dialog box, the "NC
code setting" dialog box, and then use the [NC code]
tab to congure the setting.
Select type A or type B.
Optional block skip-
ping (/)
In VPanel, open the "Settings" dialog box, the "NC
code setting" dialog box, and then use the [NC code]
tab to congure the setting.
Enable or disable optional
block skipping.
Overrides You can set the feeding speed (F) and the spindle
speed (S). Use the built-in panel to set these values.