User Manual

86
An Error Message Appears
7. Troubleshooting
Error num-
ber
Error message
(built-in panel)
Cause
Action/procedure
1047-****
The machine's inter-
nal memory cannot
be accessed.
-
Select "OK" on the built-in panel, and then press
[ENTER]. This will clear the error.
* Cutting data can be sent. However, you must not
disconnect the USB cable during cutting.
If the error occurs again after perform the above operations
Contact your authorized Roland DG Corp. dealer
1048-0000
Detected an emer-
gency stop signal
from the external
input terminal.
-
1
Check the status of the device connected to
expansion port 2.
"Setup Guide"
2
Restart the machine.
****_****
An unknown error
occurred.
-
Restart the machine.
If the error occurs again after perform the above operations
Contact your authorized Roland DG Corp. dealer.