User Manual

83
An Error Message Appears
7. Troubleshooting
Error num-
ber
Error message
(built-in panel)
Cause
Action/procedure
1023-0000
[Cutting data]
The number of the
parameters is incor-
rect.
Continue / Cancel Job
There may be a problem
with the cutting data re-
ceived from the computer.
Procedure
1024-0000
[Cutting data]
The parameter is out
of range.
Continue / Cancel Job
1
2
Select "Canceled" on the built-in panel, and
then press [ENTER]. Cutting will be canceled.
Check the cutting data.
1025-0000
[Cutting data]
A wrong command is
detected.
Continue / Cancel Job
If There Are No Problems with the Cutting Data
Exit any unnecessary programs, and then perform
cutting again.
1026-0000
[Cutting data]
The address is not
dened.
Continue / Cancel Job
If the error occurs again after perform the above operations
Restart the computer, and then perform cutting
again.
1027-0000
[Cutting data]
The parameter is not
dened.
Continue / Cancel Job
1028-0000
[Cutting data]
The operation can-
not be executed.
Continue / Cancel Job