User Manual

82
An Error Message Appears
7. Troubleshooting
Error num-
ber
Error message
(built-in panel)
Cause
Action/procedure
101F-****
The #% cutter chuck-
ing has slipped out.
(% is "1" to "6.")
The cutting conditions
may be excessively strict.
Procedure
1
Select "OK" on the built-in panel, and then
press [ENTER]. This will clear the error.
2
Review the CAM settings and the shape
specied in the CAD data.
The collet may have come
loose.
Retighten the collet.
P. 37 "Retightening the Collet"
If the error occurs again after perform the above operations
The collet may have worn out and its ability to retain the tool bur may have dete-
riorated. In this case, replace the collet, and then perform automatic correction.
1020-****
The #% cutter is too
long.
(% is "1" to "6.")
There is a possibility that
the position of the tool
holder is not correct.
1
During cutting
Select "Continue" on the built-in panel, and
then press [ENTER]. Cutting will resume.
Not during cutting
Select "OK" on the built-in panel.
1021-****
The #% cutter is too
short.
(% is "1" to "6.")
2
Replace the tool bur with one of the appro-
priate length (30 to 80 mm [1.18 to 3.15 in.]).
Also check the position of the tool holder.
P. 17 "Loadable Tool Bur Conditions"
1022-****
The #% cutter was
not found.
(% is "1" to "6.")
Continue / Cancel Job
The tool bur has not been
set or it may have been
mounted on an incorrect
stocker number.
1
During cutting
Select "Continue" on the built-in panel, and
then press [ENTER]. Cutting will resume.
Not during cutting
Select "OK" on the built-in panel, and then
press [ENTER]. This will clear the error.
2
Set the tool bur in the correct position.
There is a possibility that
the ATC magazine is out of
position.
Perform automatic correction.
P. 35 "Correcting the Cutting Machine (Automatic
Correction)"
If the error occurred during cutting
Perform steps 1 and 2, close the front cover,
and then use the built-in panel to select "Continue."
Cutting will resume.
The collet may have worn
out.
Replace the collet, and then perform automatic
correction.