User Manual

80
7. Troubleshooting
An Error Message Appears
This section describes the error messages that may appear on the machine’s display screen, and how to
take action to remedy the problem. If the action described here does not correct the problem or if an error
message not described here appears, contact your authorized Roland DG Corp. dealer.
Continue/Abort
For errors in the table that indicate , you can select whether to resume or Cancele Job after
performing the action for the error. Use the built-in panel to select "Continue" or "Canceled." The product's
quality is not guaranteed if you resume cutting.
Error num-
ber
Error message
(built-in panel)
Cause
Action/procedure
1000-****
% limit switch was
not found.
(% is "X," "Y," "Z," or "A.")
* "A" is only displayed
when a rotary axis is
connected.
The operation may be in-
hibited by cutting waste
or an obstruction.
Procedure
1
Turn o the machine's power.
2
Remove any objects blocking the operation
of the machine and any accumulated cutting
waste.
3
Turn on the power, and then resume or stop
operation.
If the error occurs again after perform the above operations
Contact your authorized Roland DG Corp. dealer.
1001-0000
The NVRAM cannot
be accessed.
-
Restart the machine.
If the error occurs again after perform the above operations
Contact your authorized Roland DG Corp. dealer.
1006-****
The % axis position
has been shifted.
(% is "X," "Y," "Z," or "A.")
* "A" is only displayed
when a rotary axis is
connected.
The cutting conditions
may be excessively strict.
1
2
Select "OK" on the built-in panel, and then press
[ENTER]. This will clear the error.
Review the CAM settings and the shape spec-
ied in the CAD data.
The motor position may
have been lost.
1
Turn o the machine's power.
2
Remove any objects blocking the operation
of the machine and any accumulated cutting
waste.
3
Turn on the power, and then resume oper-
ation.
1006-0008
The A-axis unit was
connected or dis-
connected with the
power on.
-
Restart the machine.
1017-0000
The cover was
opened during
the spindle rotating.
Continue / Cancel Job
During spindle rotation,
the front cover or the dust
box cover was opened.
(For safety, the machine
comes to an emergency
stop if a cover is opened
while the spindle is ro-
tating.)
Do not open the front cover or the dust box cover
while the spindle is rotating.
Doing so may aect the cutting results.