User Manual

Machine/VPanel Problems

7. Troubleshooting

Automatic Correction Fails

Is the detection pin or ATC magazine

dirty?

Clean away any grime on the detection pin and the ATC maga-

zine. Fouling due to buildup of cutting waste or the like on this

item may impede correct sensor operation, making detection

impossible.

P. 24 "Step 5 : Setting the Z Origin (Using the Z0 Sensor)"

Is the detection pin properly

attached?

Verify that the detection pin is properly attached. Check the

position of the tool holder on the detection pin.

"Setup Guide"

Abnormal Cutting Is Performed

Have the origins been set at correct

positions?

Check that the origins have been set correctly. If the origin loca-

tions are not correct, cutting at an unintended location or to the

wrong depth may occur.

P. 22 "Step 4 : Setting the XY Origin"

P. 24 "Step 5 : Setting the Z Origin (Using the Z0 Sensor)"

Is the command set correct?

Check that a command set that is compatible with the application

software you are using has been selected. If the command set is

not compatible, errors may occur, the machine may not operate,

or unintended operations may occur.

P. 51 ""Machine" Tab"

When the Machine Stops with the Tool Bur Inserted in the Workpiece

Procedure

Switch off the power.

Perform an emergency tool bur release.

1 Switch on the power, and then press [SPINDLE] when the following screen is displayed.