User Manual
69
7. Troubleshooting
Machine/VPanel Problems
The Power Does Not Turn On
Has the emergency stop button been
pressed?
If the emergency stop button has been pressed, the power will
not turn on. Release the emergency stop button.
P. 13 "Emergency Stop or Pause Due to Opening or Closing the
Cover"
Initial Operations Are Not Performed or Fail
Is the front cover or the dust box cover
open?
Keep the front cover and the dust box cover closed when starting
the machine. For safety, the initial operations are not performed
if a cover is open when the machine starts.
Is a large amount of cutting waste
present?
Clean away any cutting waste. Clean the area around the spindle
head especially carefully.
P. 31 "Cleaning after Cutting Finishes"
Is anything caught on the spindle head
or table?
Check whether something has become caught and is impeding
the initial operations.
Is the tool bur caught on anything?
The machine may not be able to perform the initial operations if
the tool bur attached to the spindle unit is caught on the rotary
axis unit or workpiece. Try to detach the tool bur using the built-in
panel's emergency release function.
P. 71 "When the Machine Stops with the Tool Bur Inserted in the
Workpiece"
VPanel Doesn't Start Correctly
Have the initial operations been com-
pleted?
Before you start VPanel, rst switch on the power to the machine.
P. 7 "Displaying VPanel"
Is the computer connected to the
machine?
Check whether the connector cable has come loose.
Is the driver installed correctly?
If the connection to the computer is not made according to the
procedure described, the driver will not be installed correctly.
VPanel will not function normally if the driver is not congured
correctly. Check again to ensure that the connection was made
using the correct procedure.
"Setup Guide" ("Installing the Windows Driver")
Are multiple machines connected to a
single computer?
VPanel cannot control multiple machines at the same time. Never
connect multiple instances of this machine to a single computer.