User Manual
67
"Cut" Dialog Box
"Test cut" Dialog Box
Use this dialog box to perform test cutting for the specied NC code.
- [Test]
File
This displays a list of the les and the test progress. The le currently being tested is
highlighted and
is displayed to the left of the le name. is displayed to the left
of the names of les that have already been tested.
Code
This displays the NC code written in the le. The line (block) that is currently being
executed is highlighted.
Execute the next block, and then pause the operation.
During execution, this button as well as the
and buttons are disabled.
Pause the cutting machine. Click this button again to resume operation.
This button is only enabled during operation.
Perform normal operation (a run) without pausing after each block. However, operation
will be paused in blocks that contain the "M01" command. To resume operation, click
or . During a run, this button is disabled.
Perform operations at the fastest speed at all times (a dry run). However, operation
will be paused in blocks that contain the "M01" command. To resume operation, click
[Run] or [Dry Run].
During a dry run, this button is disabled.
Coordinate System
Display
Select the coordinate system of the coordinate values displayed on the built-in panel
and on the top window.
"G55" to "G59," "EXOFS"
Override
Adjust the overrides.
Feeding
speed
Adjust the override of the feeding speed (during cutting).
Each time you click one of the arrow buttons, the value decreases or
increases by 10.
Range: 10 to 200 [%]
Spindle
rotation
Adjust the override of the spindle rotating speed.
Each time you click one of the arrow buttons, the value decreases or
increases by 5.
Range: 25 to 200 [%]
Canceled
Cancels (or continues) cutting. The "Paused" dialog box appears.
End Test
Clear the test cutting mode and close this dialog box.
The remaining blocks are output normally, and the machine continues to operate.
If you have used [Canceled] to cancel operations, the machine switches to standby.
6. VPanel Operation (Practical Use)