User Manual

62
"Settings" Dialog Box
"Move to user specied location" Dialog Box
- [Origin] tab - [Move]
Coordinate system
Select the coordinate system to use when specifying coordinate values. This is disabled
when "Amount of relative movement" is selected.
Select one of the following options.
"Machine coordinate system"
"User coordinate system" (when RML-1 is selected)
"G54" to "G59" or "EXOFS" (when NC code is selected)
Stop
Stop the tool bur movement. This button is only enabled during tool bur movement.
Coordinates
Specify the coordinate value to move to. (Absolute specication)
Amount of relative
movement
Specify the amount of movement from the current position. (Relative specication)
X, Y, Z
Enter the coordinate value of the movement destination or the movement amount.
Unit: [mm], [inch]
Move
Move the tool bur to the specied position or by the specied amount (X, Y, and Z).
A
Enter the angle or the amount of rotation of the rotary axis. This is only enabled when
the (optional) rotary axis unit is attached.
Unit: Degrees
Rotate
Rotate the rotary axis (A) to the specied angle or by the amount of rotation.
6. VPanel Operation (Practical Use)