User Manual

60
"Settings" Dialog Box
"Spindle maintenance" Dialog Box
- [Maintenance] tab - [Spindle maintenance]
Move
Move the spindle to the replacement position.
Total work time
This displays the total working time of the spindle. You cannot enter the value.
Reset
After replacing the spindle unit, click [Reset] to reset the value to 0.
Start
Start spindle run-in. (This takes approximately 40 minutes.)
"Automatic correction" Dialog Box
- [Correction] tab - [Automatic correction]
Magazine
Select this check box to detect the magazine and correct its position.
Rotary axis unit
Select this check box to detect the rotary axis and correct its position.
A origin at reference
corner of rotary axis
unit
Select this check box to set the user origin to the position where the clamp
becomes level.
Start Correction
Start automatic correction. This button is disabled during correction.
Stop
Cancel automatic correction. This button is only enabled during correction.
6. VPanel Operation (Practical Use)