User Manual

59
"Settings" Dialog Box
"Attach/detach tool" Dialog Box
- [Cutting Machine] tab - [Attach/detach tool]
Tool selection
Stocker No.
Select the ATC magazine stocker number of the tool bur to grasp. The name
of the tool bur whose number is selected is displayed in the box on the right.
Replace
Obtain the tool bur from the ATC magazine. If the spindle is holding a tool
bur, this tool bur is returned to its stocker, and then the tool bur of the se-
lected stocker is obtained.
Return
Return the tool bur to the ATC magazine.
Tool force
release
Release
Click this to forcibly release the tool bur in an emergency. Check whether
it is OK to release the tool bur once more. The retained tool bur is released
above its stocker.
"Sensing Z origin" Dialog Box
- [Origin] tab - [Set origin using Z0 sensor] - [Set]
Start sensing
Start the detection of the Z origin. When the origin is detected correctly, the tool bur
raises to its upper limit and moves to the standby position.
Abort
Cancel the detection of the Z origin. The previous Z origin is retained.
6. VPanel Operation (Practical Use)