User Manual
56
"Settings" Dialog Box
"Mail" Tab
Settings in this tab can be congured so that a notication email is sent when cutting nishes, when an error occurs, or when
maintenance is complete.
Use mail notication
Select this check box to enter each item.
Receiver address
Enter the receiver's email address. You can enter multiple addresses by separating them
with commas.
Sender address
This is the sender's email address. Enter the email address being used on the computer
on which VPanel is installed.
Sender host name
Enter the name of the outgoing mail server (SMTP server name) for the email address
entered for the sender’s address.
Sender port number
Enter the port number of the outgoing mail server for the email address entered for
the sender’s address.
Use SSL connection
Select this check box to use a security-protected connection (SSL). Select or clear this
check box according to the settings of the outgoing mail server for the email address
entered for the sender’s address.
Use SMTP authentica-
tion User name/Pass-
word
Select this check box to use authentication when sending emails. Enter the user name
and password for authentication. Select or clear this check box according to the set-
tings of the outgoing mail server for the email address entered for the sender’s address.
Send test
Send a test email. If the following email is received at the address specied with "Receiver
address," the conguration of the settings is complete.
Subject: <Machine name> Body: Test
If the sending of the email fails, the message "The email could not be sent." will be
displayed. Review the content in the input elds.
Important
* It may be impossible to send emails because of the settings of software such as security software. If emails cannot be sent,
check the settings of the security software being used as anti-virus software or for a similar purpose.
* For detailed information about the email settings, consult your network administrator.
* VPanel does not support SMTP over SSL (SMTPs).
6. VPanel Operation (Practical Use)