User Manual
52
"Settings" Dialog Box
6. VPanel Operation (Practical Use)
Pause on return from out
of range
When this check box is selected, the machine will pause when it returns within
the moveable range after performing a movement instruction outside of the
moveable range.
Initial setting: Cleared
Run VPanel at PC
start-up
When this check box is selected, VPanel will start automatically when Windows
starts, and the VPanel icon will be displayed in the task tray. Initial setting: Cleared
Tool up in pause
When this check box is selected, pausing operation will cause the machine to
decelerate and stop, raise the tool bur to its upper limit, and stop the spindle.
When this check box is cleared, the tool bur will stop wherever it is with the
spindle still rotating.
Initial setting: Selected
Attach/detach tool
Attach or detach the tool bur. Click this button to display the "Attach/detach tool"
dialog box.
P. 59 ""Attach/detach tool" Dialog Box"
"Correction" Tab
You can use this tab to congure settings related to cutting accuracy such as correcting the position of the cutting machine.
Automatic correction
Correct the ATC magazine position or the rotary axis position. Click this button to
display the "Automatic correction" dialog box. Normally use [Automatic correction].
P. 60 ""Automatic correction" Dialog Box"
Manual correction
Correct the ATC magazine position or the rotary axis position. Click this button to
display the "Manual correction" dialog box.
P. 61 ""Manual correction" Dialog Box"
Thickness of Z0 sensor
Set the Z0 sensor thickness.
Unit: [mm] only
Initial setting: 15 mm
Tool-sensor location
offset
Adjust the descended position of the tool bur when measuring the tool bur position
with the tool sensor. In situations such as when the tool sensor is damaged, you can
measure the tool bur length while avoiding the damage. If you perform automatic
correction, these values are set to "0."
Range: 0.0 mm (prescribed position) ± 3.0 mm, step: 0.1 mm
Initial value: 0.0 mm