User Manual
38
Periodic Maintenance
4. Maintenance
F
Check that the work displayed on the screen is complete, and then click [OK].
The spindle unit will move, which will open the collet.
G
When the window shown in the gure appears, click [OK].
2. Retighten the collet.
A
Tighten the collet.
1 Fit the wrench onto the collet.
Use the center triangular hole.
2 Insert the detection pin into the collet.
If the detection pin cannot be inserted, repeat the operations in steps
to under "1. Open the collet."
3 Turn the wrench in the direction indicated in the following gure.
Point
Tightening is sufcient once the wrench and the tip of the spindle unit begin to rotate together.
CAUTION
Use the included wrench and keep the detection pin inserted. If the detection pin is not inserted, the collet may
be deformed, resulting in lower cutting accuracy.
Spindle unit tip