User Manual

28
3. Cutting
3. Cutting (One Side Cutting)
When the sending of the cutting data is complete, you can disconnect this machine from the PC.
The machine can temporarily save in its internal memory the cutting data sent from the PC. Therefore, when the
sending of the cutting data is complete, you can use the PC with the USB cable disconnected.
CAUTION
Do not disconnect the machine and the PC when is displayed on the built-in panel.
Adjusting the Feeding Speed/Spindle Rotating Speed during Cutting
You can use the built-in panel to adjust the feeding speed and the number of rotations of the spindle during cutting.
Built-in panel
" P.46 "How to Set Overrides"
When is displayed, data is
being received, so you cannot
remove the cable.
When disappears, you can
remove the cable.