User Manual

27
3. Cutting
3. Cutting (One Side Cutting)
Coordinate System in RML-1 Mode
 USER: User coordinate system
Coordinate Systems in NC Code Mode
 G54 : Workpiece coordinate system 1  G57 : Workpiece coordinate system 4  EXOFS
 G55 : Workpiece coordinate system 2  G58 : Workpiece coordinate system 5
 G56 : Workpiece coordinate system 3  G59 : Workpiece coordinate system 6
Step 6 : Outputting Cutting Data
Important
Before starting cutting, check the points listed below. If there are problems with any of these, the machine
may operate unexpectedly,which may waste the workpiece or damage the machine.
• Is the output le correct?
• Is the origin location correct?
• Do the cutting conditions match the type of workpiece?
• Cutting waste and workpieces are ammable.
• Never attempt to cut magnesium or any other such ammable material.
Procedure
A
Check that the front cover and dust box cover are closed.
B
Click .
The VPanel "Cut" dialog box appears.
C
Output the cutting data.
1 Click [Add] to add an output le.
2 Click [Output].
The cutting starts.
MEMO
You can click [Test] to execute the program one line at a time. (Only when the output le is in NC code)
" P.66 ""Cut" Dialog Box"