User Manual

23
3. Cutting
3. Cutting (One Side Cutting)
D
Press the button corresponding to the axis whose origin you want to set.
Check that
is displayed next to the axis whose origin you want to set.
* A can only be used when the (optional) rotary axis unit is attached.
E
Hold down [ORIGIN].
This sets the origin. When the origin is set, its coordinate value becomes "0."
Coordinate Systems in RML-1 Mode
 USER: User coordinate system
Coordinate Systems in NC Code Mode
 G54: Workpiece coordinate system 1  G57: Workpiece coordinate system 4  EXOFS
 G55: Workpiece coordinate system 2  G58: Workpiece coordinate system 5
 G56: Workpiece coordinate system 3  G59: Workpiece coordinate system 6
The axis whose mark is
lit moves.