User Manual

21
3. Cutting
3. Cutting (One Side Cutting)
C
Check that there is no cutting waste or other debris in the stocker, and then load the tool bur.
Firmly insert the tool bur as far as possible. Up to 6 tool burs can be loaded.
MEMO
If you register the tool bur information in VPanel, you can record the work time of the actually used tool burs
and check the estimated replacement periods.
" P.65 "Registering Tool Bur Information"
Step 3 : Mounting the Workpiece on the Machine
Procedure
A
Afx double-stick tape to the workpiece.
If necessary, ax a scrap board to the workpiece, and then mount it on the machine.
B
Mount the workpiece on the table.
C
Close the front cover.
D
Press [ENTER].
Workpiece bottom surface
Double-stick tape