User Manual

19
3. Cutting
3. Cutting (One Side Cutting)
B
Load the tool bur.
CAUTION
If you load a tool bur with a length that is longer than that which can be used by this machine, an error will
occur.
When using the included table
1 Pass the tool bur through the tool holder with the orientation shown in the following gure and
ensure that the shank part is within the range indicated with "SHANK END."
2 Load the tool bur such that it does not extend past the "TABLE" line.
When a rotary axis (option) has been installed
1 Pass the tool bur through the tool holder with the orientation shown in the following gure and
ensure that the shank part is within the range indicated with "SHANK END."
2 Load the tool bur such that it does not extend past the "ROTARY" line.
ROTARY
TABLE
SHANK
END
SHANK
END
ROTARY
TABLE
60
ROTARY
TABLE
SHANK
END
SHANK
END
ROTARY
TABLE
SHANK
END
60
Scale
This is the guide-
line for the projec-
tion of the blade.
Scale
This is the guide-
line for the projec-
tion of the blade.
Ensure that the tool
bur does not project
outside of this range.
Ensure that the tool
bur does not project
outside of this range.