User Manual
18
3. Cutting (One Side Cutting)
WARNING
Do not inadvertently touch the computer or the built-in panel while performing this
task.
Unintended operation of the machine may lead to you being caught in the machine.
Step 1 : Preparing the Tool Bur
Required Items
Tool bur Tool holder * Mounting screw Tool positioner
Hexagonal screw-
driver
* For attachable tool, refer to the " Setup Guide"
The tool holder to use differs depending on the shank diameter of the tool bur.
Shank diameter
Shank diameter
Procedure
A
Load the tool holder in the tool positioner.
Place the tool positioner by aligning the holes as shown in the following gure.
Shank diameter
3. Cutting
Orient the tool
holder so that
the side with
the plastic
sheet faces up.
Plastic sheet
mm specications : 6 mm
inch specications : 0.25 in.
mm specications : 3, 4 mm
inch specications : 0.125 in.