Owner`s manual

Rev0.02

Playing back repeatedly (Repeat Function)

Use the Repeat function to play a certain section of the song

in a repeated fashion.

This function can also be combined with punch-in and

punch-out to carry out loop recording (p. 75).

fig.01-010

1. Move to the song position from which looped playback

is to be started.

2. Press [REPEAT].

[REPEAT] will start to flash and the current position will

be specified as the start position (A) for repeat playback.

3. Move to the song position at which playback is to be

looped back.

4. Press [REPEAT].

[REPEAT] will start to light up and the current position

will be specified as the end position (B) for repeat

playback.

5. To redo these settings, press [REPEAT] once again, and

turn it off.

In this condition, the start position (A) and end position

(B) for repeat playback have been cleared. Repeat Steps 1

through 4 to set new positions.

6. Move the current position to a point before (B) and start

playback.

When the song position reaches (B), it will automatically

jump to (A), and the section between (A) and (B) plays

back repeatedly.

Position

for playback

(A) (B)

•A gap of at least 0.5 seconds (approx.) is required

between the start position (A) and the end position

(B) for repeat playback. As a result, (B) cannot be set

up at a position within 0.5 seconds (approx.) of (A).

• Playback is not repeated when the playback is

started at a song position after (B).