Owner`s manual

36
Rev0.02
Turning on/off the BR-1200CD
Turning on the BR-1200CD
Use the POWER switch to turn the BR-1200CD on and off.
Once the connections have been completed (p. 34), turn on power to your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices.
fig.07-02
1 Before turning on the power, the volume of all
connected devices should be turned all the way
down.
2 Loop the AC adaptor’s cord around the cord
hook and connect its plug to the BR-1200CD’s
DC IN jack.
This will ensure that, even when the cord is accidentally
pulled, the power will not turn off as a result of the plug
being pulled out of the DC IN jack, and the jack itself
will not be subjected to excessive force.
fig.07-03
3 Plug the AC adaptor into a power outlet.
4 If any CD players, keyboards, etc. are
connected to the BR-1200CD’s input jacks, turn
on these devices first.
5 Press the BR-1200CD’s POWER switch.
The power will turn on and the opening screen will be
displayed.
fig.07-04d
After a few moments, the message “Now Checking...”
will appear, and this will be followed by the message
“Now Loading...”. When the top screen appears, it
indicates that the BR-1200CD is ready for use.
6 If an amplifier or any other similar device is
connected to the BR-1200CD’s output, this should
be turned on last of all.
POWER Switch
IMPORTANT
• Noise may be output by the BR-1200CD when the AC adapter is connected or when the power is turned on. Although
such noise does not indicate a malfunction, damage to devices and speakers may result if such actions are performed
while audio amp volume levels are turned up. For this reason, make sure that the audio amp is the last piece of
equipment that is turned on.
• In order to protect the BR-1200CD’s circuits, no operation will be possible for a short period of time after the power is
turned on.