Owner`s manual

303
Insert effect parameter functions
Section 9
Rev0.02
Release 0–100
This adjusts the time it takes for limiting to be removed once the
signal level drops below the threshold.
Detect HPF THRU, 20–2000 Hz
Adjusts the cutoff frequency for level detection. When “Thru” is
selected, this will operate as a conventional limiter.
Level -60–+24 dB
Adjusts the overall volume of the effect.
Lo-Fi Box
This effect is used to produce a lo-fi sound.
On/Off OFF, ON
This parameter turns the lo-fi box effect on or off.
Effect Type
Select the operating mode for the lo-fi box.
RADIO:
The audio will sound as if it is being played on an AM radio.
By adjusting “Tuning,” you can simulate the transient sounds that
would occur as you adjust the radio’s tuning frequency.
PLAYER:
The audio will sound as if it is being played on a gramophone. Needle
noise caused by scratches and dust on the record is also simulated.
DIGITAL:
This setting allows you to create a lo-fi sound by lowering the sample
rate and/or decreasing the number of bits. A bank of series-connected
real-time modify filters allow the sound to be freely reshaped.
■ When “RADIO” or “PLAYER” is selected
Tuning 0–100
This parameter is used with the RADIO setting. It simulates the transient
sounds that would occur as you adjust the AM radio’s tuning frequency
Wow Flutter 0–100
This parameter is used with the PLAYER setting. It simulates the wow
and flutter that occur when the speed of the turntable is not constant.
Noise 0–100
This parameter is used to simulate noise.
Filter 0–100
This parameter adjusts the filter.
D:E Balance 100:0–0:100
This adjusts the balance of the direct and effect volumes.
■ When “DIGITAL” is selected
Pre Filter OFF, ON
This filter reduces the amount of digital distortion. When turned off, it
allows you to create an intense lo-fi sound that includes digital distortion.
Sample Rate OFF, 1/2–1/32
This parameter allows you to modify the sampling rate.
Bit OFF, 15–1
Modifies the number of data bits. When turned off, the number of
data bits will remain unchanged.
If an extremely low number of bits is selected, certain input sources
may result in loud noises being input, even when there is no input
sound. In such a case, raise the noise suppressor’s threshold.
Post Filter OFF, ON
This filter reduces the amount of digital distortion produced by the
lo-fi. By turning this off, you can create an extremely lo-fi sound.
Effect Level 0–100
Adjusts the overall volume of the lo-fi sound.
Direct Level 0–100
Adjusts the volume of the direct sound.
Modify Filter
This parameter selects the filter type.
Cutoff Freq 0–100
This parameter adjusts the cutoff frequency.
Resonance 0–100
This parameter adjusts the resonance.
Gain 0– +24 dB
Adjusts the volume level of the sound that has passed through the
modify filter.
OFF No modify filter will be used.
LPF A low-pass filter will be used.
BPF A band-pass filter will be used.
HPF A high-pass filter will be used.