Owner`s manual

301
Insert effect parameter functions
Section 9
Rev0.02
Distance
Microphones often exhibit a boost in the volume of the lower
frequencies when they are positioned close to the sound
source, and this is referred to as proximity effect.
The Distance effect is used to simulate this phenomenon.
On/Off OFF, ON
This setting turns Distance on or off.
Prox.Fx -12 dB–+12 dB
This parameter is used to adjust the proximity effect, as described above.
Adjustment in the [+] direction will move the microphone closer to the
sound source; adjustment in the [-] direction, away from the sound source.
Time 0–3000 cm
This simulates the time difference occurring as a result of distance
from the sound source.
Doubling
By adding a slightly time-delayed sound to the direct sound,
a doubling effect gives the impression that multiple sources
are being played together. Best results will be achieved when
stereo output is used.
On/Off OFF, ON
This parameter turns the doubling effect on or off.
Delay Time 0.5–50.0 ms
This parameter adjusts the delay time (i.e., the interval for which
sound is delayed).
Separation -100–+100
This parameter adjusts the diffusion—in other words, the panning of
the direct sound and the effect sound to left and right. This will be
effective when stereo output is used.
Effect Level 0–120
This adjusts the overall volume of the delay sound.
Enhancer
By adding sounds that are out-of-phase with the direct
sound, this effect enhances the definition of the sound and
makes it more present in the mix.
On/Off OFF, ON
This parameter turns the enhancer effect on or off.
Sensitivity 0–100
Adjusts the manner in which the enhancer will be applied with
respect to input signals.
Frequency 1.0–10.0 kHz
Adjusts the frequency at which the enhancer will begin to be applied.
The effect will be noticeable in frequencies above the frequency set here.
Mix Level 0–100
Adjusts the amount of phase-shifted sound of the range set by
“Frequency” that is to be mixed with the input.
■ When “COSM OD BASS AMP” algorithm
is selected
Frequency 800 Hz–4.00 kHz
Adjusts the frequency at which the enhancer will begin to be applied.
The effect will be noticeable in frequencies above the frequency set here.
■ When algorithm other than “COSM OD
BASS AMP” is selected
Frequency 1.0–10.0 kHz
Adjusts the frequency at which the enhancer will begin to be applied.
The effect will be noticeable in frequencies above the frequency set here.
LowMix Level 0–100
Adjusts the amount of phase-shifted sound in the low-frequency
range that is to be mixed with the input. The extent of this low-
frequency range is fixed.
Level 0–100
Adjusts the overall volume of the enhanced sound.