Owner`s manual

300
Insert effect parameter functions
Rev0.02
Defretter
This effect simulates the sound of a fretless bass.
On/Off OFF, ON
This parameter turns the defretter effect on or off.
Sensitivity 0–100
This controls the input sensitivity of the defretter. Adjust this
parameter until your guitar’s harmonic changes sound natural.
Attack 0–100
This parameter controls the attack of the defretter. Increasing the value
will cause the harmonics to change more slowly, thus producing a
relatively attack-less sound, similar to that of a fretless bass.
Depth 0–100
This controls the ratio of harmonics. Increasing the value will increase the
harmonic content and therefore will create a more unusual sound.
■ When “COSM OD GUITAR AMP”
algorithm is selected
Tone -50–+50
Adjusts the amount of blurring between the notes.
Resonance 0–100
Adds a characteristically resonant quality to the sound.
Effect Level 0–100
Adjusts the volume of the defretter sound.
Direct Level 0–100
Adjusts the volume of the direct sound.
■ When algorithm other than “COSM OD
GUITAR AMP” is selected
Level 0–100
Adjusts the volume of the defretter sound.
Delay
This effect creates a thicker sound by applying a delayed
sound to the direct sound.
On/Off OFF, ON
This parameter turns the delay effect on or off.
Type SINGLE, PAN
This parameter selects the type of delay to be used.
* This is not displayed when the algorithm is “VO+GT.AMP” or
“VO+AC.SIM.”
SINGLE:
A simple delay.
Pan:
The delayed sound is panned across the left and right channels. This
type of delay will be effective when stereo output is used.
Feedback 0–100
This parameter adjusts the amount of feedback. Changing the
amount of feedback also causes the number of individual repetitions
of the delayed sound to change.
Effect Level 0–120
Adjusts the overall volume of the delay sound.
■ When “COSM OD GUITAR AMP” or
“COSM OD BASS AMP” algorithm is selected
Delay Time 0–1800 ms
This parameter adjusts the delay time (i.e., the interval for which
sound is delayed).
Tap Time 0–100% (Type = Pan)
Adjusts the delay time of the right channel delay. This setting adjusts
the R channel delay time relative to the L channel delay time
(considered as 100%).
Hi Cut Freq 700 Hz–11.0 kHz, Flat
This sets the frequency at which the high cut filter begins to take
effect. This allows you to get a mild effect sound by cutting the high-
end component above the set frequency.
When it is set to “Flat,” the high cut frequency is off or has no effect.
■ When algorithm other than “COSM OD GUITAR
AMP” and “COSM OD BASS AMP” is selected
Delay Time SINGLE: 1–1400 ms, PAN: 1–700 ms
This parameter adjusts the delay time (i.e., the interval over which
sound is delayed).