Owner`s manual

299
Insert effect parameter functions
Section 9
Rev0.02
■ When “COSM OD BASS AMP” algorithm
is selected
Type
This sets the type of the bass guitar preamp. The distortion and tone
characteristics of each amp are as shown below:
Gain 0 –100
Adjusts the distortion of the amp.
Bass -50 –+50 (or 0–100)
Adjusts the tone for the low frequency range.
Middle -50–+50
Adjusts the tone for the middle frequency range.
* While some amps do not feature a middle control, this control still
functions even when simulating such amps. If you want to recreate the
sound as output by the original amp, set Middle to “0.”
Middle Freq 220 Hz–3.0 kHz
Adjusts the frequency for the middle frequency range.
* You cannot set this parameter when TYPE is set to “BASS360” (it is
not displayed).
Treble -50–+50 (or 0–100)
Adjusts the tone for the high frequency range.
Bright OFF, ON
(When set to FLIPTOP, BASS360, or CONCERT)
Turns the bright setting on or off.
OFF:
No brightness is added.
ON:
Brightness is added to create a lighter, crisper tone.
Response BASS, FLAT
(When set to FLIPTOP)
This controls the overall amp characteristics. Select the position
corresponding to the characteristics for one of the two types of sound.
Deep OFF, ON
(When set to B MAN)
This switch changes the character of the lower range.
Pre Shape OFF,1, 2
(When set to T.E.)
This is a shape switch that adds a particular nuance to the midrange.
Enhancer 0–100
(When set to SESSION)
This controls the clarity and presence of the sound.
Ultra Hi OFF, ON
(when set to CONCERT)
This controls the ultra high-frequency range lying beyond treble.
Ultra Lo -, 0, +
(When set to CONCERT)
This controls the character of the lower range.
Speaker SW OFF, ON
Turns the speaker simulator on or off.
Speaker Type
Mic Setting CENTER, 1–10 cm
This simulates the microphone position. “CENTER” simulates the
condition that the microphone is set in the middle of the speaker
cone. “1-10 cm” means that the microphone is moved away from the
center of the speaker cone.
Mic Level 0–100
Adjusts the volume of the microphone.
Direct Level 0–100
Adjusts the volume of the direct sound.
De-esser
This effect is useful for reducing sibilance (or harsh ‘S’
sounds) produced by vocalists.
On/Off OFF, ON
This parameter turns the de-esser effect on or off.
Sibilant Lvl 0–100
This adjusts the sensitivity with respect to the input volume, and it
controls the way in which the effect is applied.
Level 0–100
Adjusts the overall volume of the effect.
FLIPTOP
Models the Ampeg B-15.
B MAN
Models the Fender Bassman 100.
BASS360
Models the acoustic 360.
T.E.
Models the Trace Elliot AH600SMX.
SESSION
Models the SWR SM-400.
CONCERT
Models the Ampeg SVT.
1x15”
This is a compact open-back speaker
cabinet with one 15-inch speaker.
1x18”
This is a compact open-back speaker
cabinet with one 18-inch speaker.
2x15”
This is a general open-back speaker cab-
inet with two 15-inch speakers.
4x10”
This is an optimal speaker cabinet for a
large enclosed amp with four 10-inch
speakers.
8x10”
This is a double stack of two cabinets,
each with four 10-inch speakers.
ORG
This is the built-in speaker of the amp
you selected with “Type.”