Owner`s manual

298
Insert effect parameter functions
Rev0.02
Gain 0 –100
Adjusts the distortion of the amp.
Bass 0 –100
Adjusts the tone for the low frequency range.
Middle 0–100
Adjusts the tone for the middle frequency range.
Treble 0–100
Adjusts the tone for the high frequency range.
Presence 0–100
Adjusts the tone for the ultra high frequency range.
* If you have selected “VO DRV,” “VO LEAD,” “VOCLEAN,” “MCH
DRV,” “MCHLEAD,” or “FAT MCH” as the type, raising the
presence will cut the high range (the value will change from 0 to -100).
Level 0 –100
Adjusts the overall volume of the entire preamp.
* Be careful not to raise the Level setting too high.
Bright OFF, ON
Turns the bright setting on or off.
OFF:
No brightness is added.
ON:
Brightness is added to create a lighter, crisper tone.
* This will not be displayed for certain Type settings.
Gain SW LOW, MIDDLE, HIGH
Adjusts the distortion generated by the amp, with the level
increasing in sequence for LOW, MIDDLE, and HIGH.
* The sound of each type is created with the assumption that gain is set to
MIDDLE. It is normal, therefore, to use this setting.
Speaker SW OFF, ON
Turns the speaker simulator on or off.
Speaker Type
Mic Setting CENTER, 1–10 cm
This simulates the microphone position. “CENTER” simulates the
condition that the microphone is set in the middle of the speaker
cone. “1-10 cm” means that the microphone is moved away from the
center of the speaker cone.
Mic Level 0–100
Adjusts the volume of the microphone.
Direct Level 0–100
Adjusts the volume of the direct sound.
Amb Pre-Dly 0.5–50.0 ms
This parameter adjusts the delay between the original sound and the
output of ambience (i.e., room reflections).
Amb Size 5.0–15.0 m
This parameter adjusts the sound of the ambience by varying the
room size. Larger values produce longer ambience and increase the
sense of spaciousness.
Amb Density 0–10
This parameter adjusts the density of the ambience. Larger values
produce a denser sound.
Amb HF Damp DARK, NORMAL, BRIGHT
This parameter adjusts the tone of the ambience.
DARK:
High frequencies decay relatively quickly, producing a darker
sounding ambience.
NORMAL:
This setting produces ambience with a standard sound.
BRIGHT:
High frequencies decay relatively slowly, producing a brighter
sounding ambience.
Amb Level 0–100
Adjusts the volume of ambience.
5150DRV
This models the lead channel of a Peavey EVH
5150.
MTL STK
This is a drive sound suited to metal.
MTLLEAD
This is a lead sound suited to metal.
1x10”
This is a compact open-back speaker
cabinet with one 10-inch speaker.
1x12”
This is a compact open-back speaker
cabinet with one 12-inch speaker.
2x12”
This is a general open-back speaker cab-
inet with two 12-inch speakers.
4x12”
This is an optimal speaker cabinet for a
large enclosed amp with four 12-inch
speakers.
8x12”
This is a double stack of two cabinets,
each with four 12-inch speakers.
ORG
This is the built-in speaker of the amp
you selected with “Type.”