Owner`s manual

281

Section 8

Rev0.02

Changing the content of the level meter display (Pre/Post Fader)

Normally, the level meters for the tracks, which are

displayed on the top screen, will indicate the levels that the

various signals have after they have passed through the

corresponding faders (i.e., the post-fader volumes).

You can, however, use the following procedure to have the

levels that the signals are at before they pass through the

faders (i.e., pre-fader volumes) be displayed.

fig.53-13

1. Press [UTILITY].

The Utility screen will appear.

fig.12-12d

2. Move the cursor to the SYSTEM icon and press

[ENTER/YES].

Alternatively, you can press [F2] (SYSTEM) if the

SYSTEM icon is currently displayed.

The System Parameter screen will appear.

fig.10-03d

3. Move the cursor to “Level Disp.” and select “PRE

FADER” using the TIME/VALUE dial.

fig.53-16d

PRE FADER:

The levels that signals have prior to reaching the faders

are displayed.

PST FADER:

The levels that signals have after passing through the

faders are displayed. This is the setting on the BR-

1200CD at the time of purchase.

4. Press [EXIT/NO] several times to return to the top

screen.

2,3