Owner`s manual

271
With Macintosh
Section 7
Rev0.02
8. Double-click the “BR-1200CD” icon.
All of the files and folders from the BR-1200CD’s hard
disk will be displayed on the PC monitor.
fig.52-08a
9. Double-click the USB folder.
fig.52-19a
10. Drag the WAV or AIFF file to the computer’s folder and
drop it in the folder.
11. Quit the connection to the computer.
Drug the “BR-1200CD” icon to the Trash.
12. Press the BR-1200CD’s [EXIT/NO].
The file type selection screen will be displayed once
again.
WAV or AIFF files will be automatically deleted from
the BR-1200CD’s internal hard disk.
If you press [EXIT/NO] without quitting the connection
to the computer, “Disconnect USB, OK?” appear. In this
case, pressing [ENTER/YES] returns the file format
selection screen to the display.
13. When you have finished exporting the WAV or AIFF
file(s), press [EXIT/NO] several times to return to the
Top screen.
At this point, you can safely disconnect the USB cable
from the BR-1200CD and the computer.
Loading WAV/AIFF files in
BR-1200CD tracks
(WAV/AIFF Import)
You can take WAV or AIFF files on your computer, such as
files created with audio software applications, and load them
to the BR-1200CD’s tracks.
● Wave data in the following formats can be imported.
You cannot import wave data in other formats.
• WAV or AIFF format
• Mono or Stereo
• 8-bit or 16-bit
• Sampling Rate: 44.1 kHz
● Add the extension “WAV” to imported WAV files and
the extension “AIF” to imported AIFF files.
● Compressed WAV files or AIFF files cannot be loaded.
● Extremely short waveform data (less than approximately
1 sec) cannot be loaded.
● The loop point settings within an AIFF file will be
ignored.
1. Connect your computer and the BR-1200CD with a USB
cable.
2. Confirm that the recorder is stopped, then press
[UTILITY].
The Utility Menu screen will appear.
fig.12-12d
3. Move the cursor to the USB icon and press [ENTER/
YES].
Alternatively, you can press [F1] (USB) if the USB icon is
currently displayed.
The USB screen will appear.
fig.52-05d
If the current song contains newly recorded audio
data or newly modified settings, the message “Save
Current?” may be displayed during the export
procedure. If you want to save your song before
starting the export, press [ENTER/YES]; if this will
not be necessary, press [EXIT/NO]. Remember that
if you do not save a modified song at this time, all
newly recorded audio data, edited data, modified
mixer settings, etc. will be lost.