Owner`s manual

233
Using the CD-R/RW drive to exchange data
Section 5
Rev0.02
6. To switch the format of the wave file you want to
import, press [F1] (TYPE).
[F1] acts as a toggle, switching the file format between
WAV and AIFF each time it’s pressed.
7. Move the cursor to the waveform data files you want to
import.
fig.R16-08ad
At this point, you can hear what the waveform data sounds
like by pressing [F2] (PREVIEW) (WAVE Preview).
Press [ENTER/YES] again to cancel the preview.
8. Press [F3] (SELECT).
The screen for specifying the import destination appears.
fig.R16-08d
9. Use [CURSOR] and the TIME/VALUE dial to specify
the import-destination track.
fig.R16-08bd
10. Press [F3] (LOC).
The Import Destination Location Settings screen
appears.
fig.R16-08cd
Set the following items.
START (Start point):
Specify the starting location of the import-destination track.
END (End point):
Specify the ending location of the import-destination track.
• At this time, press [F1] (DISP) to switch between ways to
specify the location (measures, time, markers).
• If, after specifying the above parameters in terms of
location you switch to the measure or marker indication,
a “+” may appear if a discrepancy between the indicated
position and the actual position arises. When using
measures or markers to make the specification, you can
use the TIME/VALUE dial in the respective screen to
eliminate the discrepancy.
• If you want the import range to be from the beginning of
the waveform data to the end, press [F3] (ALL).
11. When you have finished making the settings, press [F3]
(GO).
Copying of the waveform data begins.
When “Complete!” appears, the import is finished.
To quit copying while the import is still in progress,
press [EXIT/NO]. When the message “Cancel?” appears,
press [ENTER/YES]; the import is cancelled (it may take
some time after you press [EXIT/NO] for the message to
appear). Files imported up to the time the process is
cancelled are usable.
Copying audio track waveform data
to computers (WAV/AIFF Export)
You can write data for specified tracks to a CD-R/RW disc as
waveform data, then import the waveform data to the
computer, using your computer to read the CD-R/RW disc.
You will be unable to use CD-R/RW discs if your
computer is only equipped with a CD-ROM or CD-R
drive. In this case, used CD-R discs.
1. Place a writable CD-R/RW disc (a blank disc) in the
BR-1200CD’s CD-R/RW drive.
The drive’s access indicator will begin to flash. Wait until
this indicator stops flashing and turns off before
proceeding.
2. Press CD-R/RW [DATA SAVE/LOAD].
The Data CD Menu screen will appear.
fig.41-05d