Owner`s manual

227
Using the CD-R/RW drive to exchange data
Section 5
Rev0.02
To cancel this selection, press [F2] once again. This
deselects all songs.
6. When you have selected all of the songs you want to
back up, press [F3] (GO).
The message “Write Speed?” will appear.
fig.41-03d
7. Use the TIME/VALUE dial to set the write speed.
8. Press [ENTER/YES].
If you want to cancel the backup, press [EXIT/NO].
The message “Write Sure?” will appear.
fig.41-04d
9. Press [ENTER/YES] once again.
The BR-1200CD will begin writing data to the CD-R/RW
disc.
When the message “Complete!” appears, it indicates that
the backup has been successfully completed.
Reading backup songs back into
the hard disk (Song Recover)
1. Insert a CD-R/RW disc containing backup songs into
the BR-1200CD’s CD-R/RW drive.
The drive’s access indicator will begin to flash. Wait until this
indicator stops flashing and turns off before proceeding.
2. Press CD-R/RW [DATA SAVE/LOAD].
The Data CD Menu screen will appear.
fig.41-05d
3. Move the cursor to RECOVER icon, and press [ENTER/
YES].
Alternatively, you can press [F2] (RECOVER) if the
RECOVER icon is currently displayed.
The Recover screen will appear.
fig.41-16d
4. Press [F1] (SONG).
A list of the CD-R/RW disc’s backup songs will be
displayed.
fig.41-17d
5. Move the cursor to the song you want to recover and
press [F1] (SELECT).
The song will selected for recovery.
A number of songs can be selected in this way for
recovery, and an asterisk (*) will be displayed for each
selected song. To cancel this selection, press [F1] once
again.
If you would like to recover all of the songs on the CD-
R/RW disc in a single operation, press [F2] (ALL). All
songs will be selected for recovery.
To cancel this selection, press [F2] once again. This
deselects all songs.
6. When you have selected all of the songs you want to
recover, press [F3] (GO).
The BR-1200CD will start the recovery process. When the
message “Complete!” appears, it indicates that the
recovery has been completed successfully.
• The range of available write speeds can sometimes
be limited by the type of media being used. In such a
case, the BR-1200CD will allow you to select only the
supported speeds.
• If an error occurs, try changing the write speed and
then carry out the writing process over again.
• The actual time required to complete writing to a
disc will be longer than the time calculated from the
write speed. The data is converted into CD format
during the writing process, and this accounts for the
extra time requirement.
The recovered songs will be saved in sequence on
the hard disk using the available song numbers.