Owner`s manual

212
Using a metronome
Rev0.02
Selecting metronome sounds
Now that we can hear the metronome, let’s select sounds to
be used.
1. Press PROGRAMMABLE RHYTHM
[ARRANGEMENT/PATTERN] so the PATTERN
indicator is lighted. (Pattern mode)
2. Press PROGRAMMABLE RHYTHM [EDIT].
The Pattern Selection screen will appear.
fig.21-43d
3. Move the cursor to “METRO” and select a sound type
using the TIME/VALUE dial.
Available sound types
BEEP:
This sets up a beep-type metronome, with a higher-
pitched beep being used for the first beat of each
measure.
CLICK:
This sets up a click-type metronome, with a louder click
being used for the first beat of each measure.
4. When you have selected the type of sound you want to
use, press [EXIT/NO] several times to return to the top
screen.
5. If you wish to store the sound-type selection, save the
current song (p. 70).
Adjusting the Metronome and
Loop Phrase Volume Balance
While the balance between the metronome and loop phrase
volume levels is normally adjusted with the Track 9/10
fader, you can use the following procedure to further adjust
the metronome and loop phrase volume balance.
1. Press [TRACK TYPE SELECT].
The Track Type Select screen will appear.
fig.20-004d
2. Move the cursor to “LEVEL DR” and “LEVEL LP,” then
use the TIME/VALUE dial to adjust the volume level of
the metronome and Loop Phrase, respectively.
LEVEL DR:
In this case, adjusts the volume of the metronome. The
volume increases as the value is raised. When set to 0, no
sound is output. Set this to 100 when no adjustment is
needed.
LEVEL LP:
This adjusts the volume of the Loop Phrase. The volume
increases as the value is raised. When set to 0, no sound
is output. Set this to 100 when no adjustment is needed.
The sound-type selection will be used both in
Arrangement mode and in Pattern mode.