Owner`s manual

179
Creating bass patterns
Section 4
Rev0.02
Correcting bass patterns
(Microscope)
Microscope is used to made detailed corrections to bass
patterns. In specific terms, this function displays a bass
pattern’s performance data in list format so that any of the
corresponding parameters can be corrected as required.
1. After carrying out the steps described in “Preparing for
recording,” press [F2] (REC).
The Pattern Recording Selection screen will appear.
fig.20-065d
2. Press [F3] (M.SCOPE).
The Microscope screen will appear.
Performance data is displayed on this screen as follows.
fig.20-069d
3. Move the cursor to the parameter whose setting you
want to change and select a new value using the TIME/
VALUE dial.
You can confirm the sound where the cursor is
positioned by pressing [ENTER].
To change a bass note:
1) Move the cursor to “NOTE” field.
fig.20-069ad
2) Select a new note number using the TIME/VALUE
dial.
The performance data will be updated with this new
note setting.
To change a bass note’s volume:
1) Move the cursor to “ACC” field.
2) Set a new velocity value using the TIME/VALUE
dial.
Larger velocity values produce higher volumes and
vice versa.
To change a bass note’s gate time:
1) Move the cursor to “GATE” field.
fig.20-069b
2) Set a new value using the TIME/VALUE dial.
The performance data will be updated with this new
gate time setting.
To move an item of performance data:
1) Press [F2] (MOVE).
2) Use the TIME/VALUE dial to select the time position
to which the performance data is to be moved.
3) Press [ENTER/YES].
The performance data will be moved to this new
position.
To delete an item of performance data:
1) Press [F3] (DELETE).
The selected item of performance data will be deleted.
To insert a new item of performance data:
1) Press [F1] (INSERT).
An item of performance data will be inserted at the
current position.
4. Press [EXIT/NO] to end Microscope editing.
The Pattern Recording Selection screen will appear once
again.
fig.20-151d
5. Press [EXIT/NO] once again.
The Bass Pattern Edit screen will appear once again.
fig.04-0831d
6. Press [F3] (WR•CPY•DEL).
The Write screen for bass patterns will appear.
fig.20-054d
Location
Accent
(Velocity)
Note number
Gate time
(the length of time from when the note
begins to the time it stops playing)