Owner`s manual

171
Section 4
Rev0.02
Using bass
Setting the track type
To use bass, you must first of all set up Track 8 as a Bass
track using its track type setting.
fig.20-044
1. Press [TRACK TYPE SELECT].
The Track Type Select screen will appear.
fig.20-003d
2. Move the cursor to “TRACK 8” and select “BASS”
using the TIME/VALUE dial.
fig.20-046d
AUDIO:
The track will be used for recorded audio.
BASS:
The track will be used for bass.
3. Press [ENTER/YES].
The Track Type Select screen closes.
The BASS indicator from TRACK TYPE SELECT will
light up to indicate that Track type has been set up for
use as a bass track.
You will now be able to use bass.
4. If you wish to store the track type setting, save the
current song (p. 70).
Playing bass
Simply changing the track type may not be sufficient to allow
bass to be played. Use the following procedure in such a
case.
1. Press the track button for Track 8 several times until it
lights up.
Pressing the button repeatedly allows you to cycle
through the available choices, which are: Flashing → On
→ Off.
Off:
No bass sounds will be played.
Flashing:
Bass sounds will be played only when the BR-1200CD is
recording or performing playback.
On:
Bass sounds will be played even when the BR-1200CD is
stopped.
2. Raise the fader for Track 8 to a suitable level.
You will now be able to hear the bass sounds.
1
2
3
2