Owner`s manual

144
Recreating the characteristics of different monitor speakers (Speaker Modeling)
Rev0.02
6. Press [EXIT/NO] to return to the Speaker Modeling
patch screen.
fig.37-08d
In order to indicate that the Speaker Modeling settings
have been temporarily changed, the patch number will
be displayed as “*TMP.” If you select a different patch,
load a different song, or turn off the BR-1200CD while
“*TMP” is being displayed, all of the patch settings will
return to their original condition. As it may not be
possible to restore these settings, due caution should be
observed.
To save your modified settings, carry out the procedure
described below in “Saving Speaker Modeling settings.”
Saving Speaker Modeling settings
Modified Speaker Modeling settings are saved by writing
them together under a new patch name.
1. Press [F1] (NAME) on the Speaker Modeling edit screen.
fig.37-09d
2. Move the cursor to the characters in the patch name you
want to change and select new characters using the
TIME/VALUE dial.
fig.37-09d
3. Press [EXIT/NO] twice to return to the Speaker
Modeling patch screen.
4. Press [F3] (WRITE•COPY).
The Speaker Modeling Patch Write/Copy screen will
appear.
fig.37-10d
5. Move the cursor to the destination patch number and
select a destination patch using the TIME/VALUE dial.
fig.37-11d
This field should be left unchanged at “*TMP(CURRENT).”
If a different message is displayed, however, move the
cursor to this field and turn the TIME/VALUE dial
counterclockwise to restore “*TMP(CURRENT).”
6. Press [F3] (GO).
The Speaker Modeling patch will be written. When the
message “Complete!” appears, it indicates that writing
has been completed.
7. Press [EXIT/NO] several times to return to the top
screen.