Owner`s manual

123
Using insert effects
Section 3
Rev0.02
Copying insert effect settings
The BR-1200CD’s function for copying patches proves
extremely useful when you want to create a number of effect
patches with slightly different settings.
1. Press [F3] (WRITE•COPY) on the Effects Edit screen.
The Effects Patch Write/Copy screen will appear.
fig.31-06d
2. Move the cursor to the copy-source patch number and
select the effect patch to be copied using the TIME/
VALUE dial.
Note that you can also move the cursor to the bank field
and turn the TIME/VALUE dial to select a source bank.
“*TMP(CURRENT)” may be displayed in this field when
you call up the Effects Patch Write/Copy screen after
modifying patch settings, this may be freely changed.
3. Move the cursor to the destination patch number and
select a destination patch using the TIME/VALUE dial.
Note that you can also move the cursor to the bank field
and turn the TIME/VALUE dial to select a new
destination bank.
4. Press [F3] (GO).
The effect patch will be copied. When finished, the
message “Complete!” will appear and the display will
automatically return to the Effects Patch screen.
If you selected a different destination bank than that set
by pressing the INPUT SELECT button, this new bank
selection will be maintained after copying has been
completed.
5. Press [EXIT/NO] several times to return to the top screen.
It is important to remember that the destination patch
will be completely overwritten by the patch specified
with copy-source patch. Care should be taken to ensure
that important patches are not accidentally overwritten
in this way.
Changing insert effect connections
(Insert Effect Location)
Whenever you create a new song, the insert effects will be
initially inserted into the input channels, and this is done to
ensure that performances can be monitored and recorded
with the effects applied. You can, however, modify this
connection pattern if so required. By changing the insert
effect connections as described below, you can set up the BR-
1200CD for use in various different situations.
1. Press [EFFECTS].
The Effects Patch screen will appear.
fig.31-01d
2. Press [F2] (LOCATION).
The Effects Location screen will appear.
fig.31-10d
3. Change the connection using the TIME/VALUE dial.
fig.31-11d
4. Press [ENTER/YES] to close the message.
5. Press [EXIT/NO] several times to return to the top
screen.
6. If you wish to store the modified connections, save the
current song (p. 70).
When the track type for Track 9/10 is set to
“DRUMS&LP,” the effects are applied only to the drums
when “TRACK 9/10” is selected. The effects are not
applied to Loop Phrases. Also note that the effects are
not applied to the metronome or Loop Phrases when the
Track 9/10 track type is set to “METRO&LP.”
If you load another song or turn off the BR-1200CD
without saving the current song, your changes will be
lost.