User`s manual



While viewing the preview, make the following settings, then start scanning.

Scanning pitch

Using a ne setting can reproduce details more accurately, but the amount of memory required increases, and scan-

ning takes longer time.

Scanning area

Specify the minimum area that allows the entire object to be scanned, thereby speeding up scanning time.

(The following settings are only for plane scanning.)

The number of scanning surfaces

You can specify from one to as many as six surfaces. It's a good idea to decide on the number of surfaces to match

the shape of the object.

Scanning angle

Specify the incident angle of the laser for each surface. It may be a good idea to set the preview to Top View.

Setting screen for scanning (Plane Scan)



When scanning ends, the results of scanning appear.

 Go to "2-3 Performing Scanning," see "Checking the Scanning Results."

This changes to the surface

whose scanning angle you

want to set (plane scan only).

This sets the scanning angle

(plane scan only).

Clicking this button

starts scanning.

This displays the amount of

memory that scanning requires.

Clicking the button displays the

estimated scanning time.

This sets the scanning area.

During rotary scan, these set the

"Height Direction" and "Circumfer-

ential" pitch values.

This sets the number

of scanning surfaces

(plane scan only).

This changes the orientation and

perspective for the preview.

These let you switch between Top View

and Front, and expand or reduce the

view.

This sets the scanning pitch.

During rotary scan, these make the

settings for "Height" and "Circumfer-

ence."

2-3 Performing Scanning

2. Creating 3D Data