User`s manual

2-3 Performing Scanning
Once you have mounted the object of the machine, you can now perform scanning.
Before you start scanning, make sure the door is closed and turn on the machine.
Basic Scanning
This is the scanning that you perform rst after mounting the scan object. The scanning data obtained by executing basic scan-
ning makes possible a wide variety of operations.
Procedure

Start Dr.PICZA3.
From the [Start] menu, choose [All programs (or Programs)], then [Roland Dr.PICZA3], then [Dr.PICZA3].

Click the [ ] button.
The [Scan] dialog box appears.

Choose the scanning mode that matches the shape of
the scan object.
The [Settings for Scanning] dialog box appears.
 Object whose shape is close to a sphere or cylinder
 Object with little unevenness
Choose rotary scanning.
 Other object
Choose plane scanning.
You normally choose plane scanning, which has little
restrictions as to shape.

Click the [ ] button.
The preview starts.
From this point on, never open the door until scanning ends. Doing so switches o the power. Scanning cannot be resumed
when you then switch on the power again.
Click one of these buttons.
Click
Preview in progress
The general shape
of the object to be
scanned is displayed.
After preview has nished
The height of the scanning area is
setting automatically at this time.
32
2. Creating 3D Data