User`s manual

1-3 Installing and Setting Up the Software
Here you connect the machine to your computer and install and set up the included software on the computer, enabling
you to perform scanning with the machine.
Installing the Driver
Connect the machine to the computer and install the driver.
Be sure to follow this procedure to install the driver. Failure to do so may make installation impossible.
 Go to "1-3 Installing and Setting Up the Software," see "What to Do If Installation Is Impossible."
Procedure
Windows XP

Start Windows and log on as "Administrator."

Insert the Roland Software Package CD-ROM into
the CD-ROM drive.
The setup menu appears automatically.

Switch on the machine.
Wait a short while until the lights stop ashing.
The ashing continues for about one minute.
From this point on, keep the machine's door closed
until installation ends. Failure to do so switches o the
power, which may prevent installation from completing
correctly.

Connect the included USB cable.
The [Found New Hardware Wizard] dialog appears.
USB connector USB cable
These lights ash
clockwise two at a time.
Press the power button.
USB port
The rear of
the machine
Computer
16
1. Preparing the Machine