Setup guide

59
10. When Moving the Unit
Procedures from Preparing to Move Through Reinstalling
To move the machine, you must completely drain all ink inside the machine and secure the print heads in
place with packing materials to protect them. Attempting to move the machine without rst doing this may
result in damage to internal components due to leaking ink or damage to the heads. This operation requires
four unused SOL INK cleaning cartridges. Have these on hand before you start.
Important Notes on Moving
 Be sure to use SOL INK cleaning cartridges. Use of any other type may result in break-
down.
 Once the preparations for moving are complete, move the machine and ll it with ink with
as little delay as possible. Allowing the machine to stand without ink may damage the print
heads.
 When moving the machine, keep it at a temperature between 5 to 40˚C (41 to 104˚F) and at
relative humidity between 20 to 80% (with no condensation). Failure to do so may result in
breakdown.
 Handle the machine with care when moving, keeping it level (not tilted at an angle) and pre-
venting it from striking other objects.
1. Drain the ink and wash the interior.

Press .

Press several times until the screen shown on the
left appears.
Press
w
Press several times until the screen shown on the
left appears.
Press
in this order.

Press .

Make sure the SOL INK cleaning cartridges are ready.
Press
.

Discard the discharged ink in the drain bottle.
Be sure to discard the discharged ink.
Press .
{
Thereafter, follow the on-screen instructions to carry out the operations.
After cleaning has nished, the sub power is automatically switched o.
Insert each color ink cartridge into the slot labeled with the matching color. If you insert wrong car-
tridges when lling ink, the condition cannot be restored easily. Contact your authorized Roland DG
Corp. dealer or us., if you lled ink with wrong cartridges inserted.
MENU
SUB MENU
SUB MENU
INK CONTROL
INK CONTROL
HEAD WASH
CLEANING LIQUID
IS REQUIRED
CHECK
DRAIN BOTTLE