Owner`s manual

Using the JUNO-Di Editor

• By clicking the buttons in the Navigation block you can select the parameters that will be shown in the Main block.

• The Main block is the editing area for the parameters you selected in the Navigation block.

The [READ]/[WRITE]/[SYNC] buttons are located in the top line of the main window.

Loading the settings

To load the JUNO-Di’s settings into JUNO-Di Editor, click the [READ] button.

The settings of the patch currently selected on the JUNO-Di will be loaded.

Writing the settings

To write the edited data to the JUNO-Di, click the [WRITE] button.

The data that will be written (patch or rhythm set/performance/system) will depend on the parameter that is currently

selected.

Synchronizing the settings

To synchronize the JUNO-Di with the Editor, click the [SYNC] button.

This is a command that you will need to use only if using JUNO-Di Editor together with JUNO-Di Librarian.

For details, refer to

5. Notes Concerning Use of JUNO-Di Editor Together with JUNO-Di Librarian

(p. 7).

4. Using the JUNO-Di Editor

4-1. Reading/writing/synchronize settings

Navigation block Main block